Description
Device used to intercept sediment-laden sheet flow, and allow sediment to settle prior to discharging off-site.
Applications
- Along the site perimeter.
- Along streams and channels.
- Utility trench barriers in channels.
- Across swales and small catchments.
- Diversion dike or berm.
- Below toe of exposed slopes.
- Temporary sediment trap.
- Around stockpiles.
- Weigh down inlet protection devices.
Installation and Implementation Requirements
- Install bags end-to-end along a level contour.
- Turn ends of sandbag barrier up slope to prevent flow around ends.
- May be used in combination with soil stabilization controls up slope.
- Stack sandbags cross-sectionally in a pyramid formation if bags are to be stacked higher than 2 bags. If additional reinforcement is used, then stack sandbags in a brick wall formation.
- Materials for sandbag barrier shall comply with the following:
- Sandbag shall be woven polypropylene or polyamide fabric with ultraviolet protection to avoid rapid deterioration of fabric.
- Bag dimensions can vary but must be able to withstand anticipated flows.
- Fill material shall consist of non-cohesive, permeable material free of fines from clay and deleterious material.
- Sandbag barriers are allowed to be used in-stream provided that they will not become flood hazards, sandbag contents do not leak into the stream bottom, and they are removed once the project is completed.
Considerations
- Drainage area shall not exceed 5 acres.
- Avoid installing at locations which may compromise traffic safety.
- Burlap material shall not be used for sandbags.
- Does not filter sediment.
- Bags degrade when exposed to sunlight.
- Not adequate for long-term projects.
- Depending on application, installation may require an adequate amount of manpower.
- Not ideal for concentrated flows.
What to Inspect
- Has sediment accumulated?
- Does the sandbag have tears or rips?
- Are sandbags evenly spaced to weigh down inlet protection?
- Does the sandbag need to be replaced or reoriented?
- Is there evidence of erosion undermining the sandbag barrier?
- Is water bypassing the sandbag barrier?
Maintenance
- Reshape or replace sandbags as necessary.
- Remove and properly dispose of sediment, which has accumulated to a depth of 6 inches.
- Remove sandbags if they are no longer in use. If the area needs to be stabilized, do so immediately after removal.


BMP Examples
Are adequate BMPs installed to prevent the discharge of pollutants from the project site? Hover over each photo for an explanation of the situation presented and if BMPs have been installed properly.









