Description
Stabilization and maintenance of temporary construction roads and parking areas after grading to minimize erosion and dust from vehicular traffic.
Applications
- Temporary construction roads.
- Parking areas for construction equipment and vehicles.
- On-site vehicular routes.
- Areas where sediment tracking may be a problem during wet weather.
- Areas where dust may be a problem during dry weather.
- Areas adjacent to bodies of water.
- Along steep grades or areas where additional traction is necessary.
Installation and Implementation Requirements
- Grade roadway to follow topographic contours to reduce erosion and divert surface water off the roadway.
- Roadway grade shall not exceed 15%.
- Properly grade roadway to prevent runoff from leaving site.
- Stabilize the temporary construction roads and parking areas with aggregate, asphalt cement, or concrete.
- The aggregate layer shall be a minimum of 4 inches deep. The base shall consist of HDOT approved 2- to 3-inch coarse aggregate and shall be applied immediately after grading.
- Place geotextile filter fabric beneath the aggregate.
- Consider existing storm water flows when designing construction roads or parking areas. Remove or convert to permanent roadway upon completion of construction.
- Does not replace requirements for a construction entrance/exit.
Allowable Materials | Not Allowable Material |
|
|
Considerations
- Although allowed under certain circumstances by the 2005 Hawaii Standard Specifications for Road and Bridge Construction, whenever possible, avoid chemicals stabilization methods, which may contribute to soil pollution and increase runoff.
- Construction traffic management may be subject to air quality control measures. Contact the local air quality management agency for more information.
- Roadway grade and site conditions.
What to Inspect
- Is there sediment buildup within aggregate?
- Is there dust generated from vehicles traveling on construction roads?
- Is the proper aggregate type and size being used?
- Is there geotextile under the coarse aggregate?
- Is there evidence of tracking on public roads?
Maintenance
- Periodically apply additional aggregate to refresh void spots on construction roads and parking areas.
- Remove sediment on the aggregate periodically to minimize polluted runoff.
- Temporary construction roads may require frequent dust control.
- Reshape roadway as needed for drainage and runoff control.
BMP Examples
Are adequate BMPs installed to prevent the discharge of pollutants from the project site? Hover over each photo for an explanation of the situation presented and if BMPs have been installed properly.




